Line 6 PX-2 Review

Average Reviews:

(More customer reviews)While I detest Line6's unwillingness to let the OneSpot power adaptor do the trick, this is an excellent, full length adaptor. I've managed to use it very conveniently, providing power from across the room, snaking under my bed and desk to my DL4.

Click Here to see more reviews about: Line 6 PX-2

This 9-Volt AC power supply is designed for the Stompbox Modelers (DL4, MM4, DM4, AM4, and FM4), POD, PODXT, and Variax. It is intended for use in the USA, Canada, and other countries with 120-Volt power standard. Features a US-style power plugs and 120-Volt operation. (Note: This power supply is a suitable replacement for all similar voltage PX-1 power supplies.)

Get 20% OFF

Click here for more information about Line 6 PX-2

Read More...

Digitech PSS3-120 Power Supply for GNX2, GNX3, GNX3000, GNX4, J-Station Review

Average Reviews:

(More customer reviews)I've had 2 problems with this adapter:
1. If you use this with a less stable power supply (e.g. a generator) that's not load-balanced, it likely will fail - I've blown out 3 of these under such conditions and the GNX 3000 I use it with doesn't run on batteries and there's no protection circuitry in either. Note that other power supplies with other effects pedals on the same circuit did not fail and were fine. There's no fuse in either the GNX 3000 or the power supply system (which would be a nice cost-saving measure), so you're stuck with replacing the power supply. I recommend keeping a spare on hand.
2. the wire/ wire support on the low voltage side isn't very good. If you transport it around and use it a lot, the wire will break eventually so treat it carefully.
So, compared to other power supplies on other electronics, it's inferior, but it's the only choice you have.

Click Here to see more reviews about: Digitech PSS3-120 Power Supply for GNX2, GNX3, GNX3000, GNX4, J-Station

output: 9VAC 2.1A; polarity: N/A (AC output). Works With: GNX2; GNX3; BNX3; Genesis 3.

Get 40% OFF

Click here for more information about Digitech PSS3-120 Power Supply for GNX2, GNX3, GNX3000, GNX4, J-Station

Read More...

Boss FS-5L Latching Footswitch Review

Average Reviews:

(More customer reviews)I use the FS-5L with my AC-60 and previously used it with my BC-60 Bluescube. The red LED light is great for channel switching and it only takes a single AA battery to power it. The battery lasts a long time. The pedal is designed to interlock with your other FS series pedals. The downside to this switch is the price and the sharp aluminum corners. If you put this in your gig bag it will be torn to shreds. The plastic pedal itself can be slippery and is a relatively small surface.


Click Here to see more reviews about: Boss FS-5L Latching Footswitch

The FS-5L is a sturdy, metal, latch-type footswitch with an LED to indicate status. It can be connected using an ordinary guitar cable.

Get 37% OFF

Click here for more information about Boss FS-5L Latching Footswitch

Read More...

Digitech PS0913B Power Supply for JHE, XAS-BM, JamMan, Whammy, EX7, GNX1, RP100-350, RPx400, BP200, Vocal 300, Vx400, EXH, VL2, VL4, HarmonyMan, TimeBender Review

Average Reviews:

(More customer reviews)I have had my RP250 for a couple of years. I had no problems with the power supply until this week.
The cord became loose where the cord goes into the power supply adapter box(that plugs into the wall). I went to power up my RP250 and it flashed liked it was coming on, but ultimately had no power. I jiggled the cord (lightly) and found it to be coming loose at the box.
I have been careful with the RP250 and with the power supply. I guess I could have accidentally pulled on the cord too hard but I don't think so.
So now I'm out the extra money for a new power supply and it seems to be a bit expensive, especially considering how much I paid for the RP250 just a couple of years ago.
But, I don't have much choice. It needs power to work, and this will do that.
Digitech should consider providing a more robust (better built) power supply.

Click Here to see more reviews about: Digitech PS0913B Power Supply for JHE, XAS-BM, JamMan, Whammy, EX7, GNX1, RP100-350, RPx400, BP200, Vocal 300, Vx400, EXH, VL2, VL4, HarmonyMan, TimeBender

Digitech PS913B 9VAC power supply for the RP Series pedals. AmericanMusical.com is an authorized dealer of DigiTech products.

Click here for more information about Digitech PS0913B Power Supply for JHE, XAS-BM, JamMan, Whammy, EX7, GNX1, RP100-350, RPx400, BP200, Vocal 300, Vx400, EXH, VL2, VL4, HarmonyMan, TimeBender

Read More...

Pignose AC9 Power Supply for Pignose 7100 Review

Average Reviews:

(More customer reviews)This is the BEST damn AC power adapter that I've ever had in my entire lifetime (and I've had dozens). So order a Pignose amp just for the privilege of owning one of these miracles of craftsmanship.

Click Here to see more reviews about: Pignose AC9 Power Supply for Pignose 7100

9 volt AC adpater for the Original Legendary 7100 Pignose amp. Fits into the back of the amp for convenience. Just plug it into the wall and save on batteries when you're at home or anywhere close to an AC outlet. This is a budget-minded alternative to Pignose's regulated adapter. AmericanMusical.com is an authorized dealer of Pignose products.

Get 37% OFF

Click here for more information about Pignose AC9 Power Supply for Pignose 7100

Read More...

Tascam CD-VT2 CD Vocal and Instrument Trainer Review

Average Reviews:

(More customer reviews)Not everyone has a need for this but if you do, it works very well. It plays a CD well enough although if that's all you need then don't buy this. What it does well is it can either speed or slow the tempo of what is on the CD without changing the pitch, or it can change the pitch of what is on the CD without changing the tempo. It also acts as a tuner. And, it can remove center channel vocals if you want to just hear the music portion of what is on the CD.
Regarding the tempo and pitch change, it executes these tasks flawlessly.
Regarding the vocal elimination, it removes the vocals satisfactorily. I don't think any machine can do a perfect job because there's too many hitches inherent in the recording, but this one does a good enough job so that the vocals are faint enough for someone to sing over and not compete with them.
Build quality is good - it is part of the Teac company and they make quality stuff. I bought a separate power transformer for this unit so I didn't have to worry about batteries, so I have no comments regarding how long the batteries last.
The controls and functions are neatly laid out on the panel and are easy to use. The instruction book is easy to follow. This product does what I bought it for very well so I am happy with it.


Click Here to see more reviews about: Tascam CD-VT2 CD Vocal and Instrument Trainer

Featuring an improved compact design, the Tascam CD-VT2 CD vocal/music trainer allows artists, musicians, students, and music teachers to practice, learn and teach vocal harmonies, fast rap passages and complex melodies from their favorite music. It offers comprehensive LCD display with graphical user interface, album title/track title indication by CD-Text, expanded effect banks for user preset, chromatic tuner.
Tascam's VSA feature (Variable Speed Audition, pitch control without affecting key) lets you learn a continuous mix of your favorite songs anywhere you go, while Flash Back, loop, and other play functions help review parts without having to constantly reach for the controls. The CD-VT2 also includes a vocal/instrument canceller, allowing you to play along to featured parts with your own vocal or instrument.

Key Features
Portable CD Music/Vocal trainer (More compact than previous CD-VT1MKII)
CD-DA/CD-R/CD-RW disc playback
10 second anti-shock memory
Comprehensive 128 x 64 dot matrix LCD display with graphical user interface
Album title/Track title indication by CD-Text
Elapsed Time/Remain Time display with bar meter
+16 to -50% pitch control in 1% steps
VSA (Variable Speed Audition, pitch control without affecting key)
Key control: +/-6 semi-tone, in semi-tone steps with +/-50 cents fine tune
Single play and continuous play
Single Loop, All Loop, and Seamless IN-OUT Loop
Flash Back function (Instant review up to 5 seconds prior playback)
Vocal/Instrument Canceller with selectable canceling pan point and selectable frequency range
10 effect banks for user preset
Chromatic tuner with calibration (435 to 445Hz)
3 octaves tone oscillator
Metronome (BPM: 40 to 220, Beat: 2 to 6)
(2x) 1/4-inch Mic input
Mic input volume
Mic input level meter indicator on LCD display
CD level meter indicator
Foot switch connector
5 selectable functions by foot switch (Flash Back, Rewind, FF, Bank, Effect on/off)
1/8-inch stereo line output
1/8-inch stereo headphone output
Headphone volume
MONO monitor for CD (L+R, L, R)
Split monitor (Left ch: CD, Right ch: Input or vice versa)
Battery operation
Optional power supply PS-P520

Specifications
Disc Type: 8cm and 12cm CD
Line Output Connector: 1/8-inch Stereo mini connector
Nominal Stereo Output Level: -10dBV
Output Impedance: 600ohm (2V RMS)
Maximum Output Level (LINE OUT): +6dBV
Headphone Output Connector: 1/8-inch Stereo mini connector
Maximum Output Level (PHONES): 15mW (at 32ohm loaded)
Mic Input Connectors: 1/4-inch Phone Connector
Nominal Input Level, Mic Input: -40dBV
Maximum Input Level, Mic Input: -19dBV
Frequency Response: 20 Hz to 20 kHz (-3/+1dB); (A weight filter + 20KHz LPF)
Signal to Noise Ratio: Better than 85 dB
Total Harmonic Distortion: < 0.03% (200Hz HPF + 20KHzLPF)
Channel Separation: Better than 80dB (A weight filter + 20KHz LPF)
Power Requirements: DC 5V (Optional AC adapter PS-P520); AA batteries x 4
Power Consumption: 4W (with PS-P520)
Dimensions: 7.64 x 1.52 x 5.43 inches (WxHxD)
Weight (excluding batteries): 19.4 ounces

Click here for more information about Tascam CD-VT2 CD Vocal and Instrument Trainer

Read More...